The 540R is a special version of the 540* Laterals. It maintains the traditional 180 degrees front pipe and 360 degrees rear pipe. Except it enables a higher extent of modifications to your Sportster by allowing you to install rearsets with the proper clearance. With this system, like all of our exhausts, its 100% 304 stainless steel, fully TIG welded, and tested multiple times during and after production for perfect fitment. These will work for both mid controls as well as rearsets. It will NOT work for forward controls.
Segmented Welds : A more raw look known as "pie cuts" on piping. It is multiple weld fragments along the pipe.
O2 Bungs : If you have a 2007-2017 Sportster, you will NEED O2 bungs. It's essential for air/fuel ratio mixture. (Unless you're running o2 eliminators.)
Slash Cuts : Adds a bit of sharpness to the ends by having it cut at an angle versus the conventional straight pipe. Note that if you choose the slash cut option, you cannot choose the 2-1 option, so choose N/A for the 2-1 option.
2-1 Option : A 2 to 1 option is available for this exhaust, it will come with our handmade, TIG welded stainless muffler cone, fully resonated and slips on at the collector for easy removal. Note that if you choose the 2-1 option, you cannot choose slash cuts, so choose N/A for the slash cut option.
Integrated Flange Kit: With our flange kit, you don't have to reuse your OEM flanges. That can be a nuisance because the OEM flanges are snap-ring equipped, requiring special tools and more time to install/remove the exhaust. This adds convenience and less fragile parts to your exhaust system thus, simplifying it all around.
•Mandrel bent 304 stainless steel.
•1.75" inches at flange, then tapers to a full 2".
•Fits 1986+ Sportster of all trims. (Nightster, Forty-Eight, Seventy-Two, Iron)
•O2 Sensor bungs added for fuel injected Sportsters.
•Internally ceramic coated for heat control.
•Works with rear-sets & mid controls.
•These are made-to-order, turn around time is 2 weeks.
•Worldwide Shipping Available